FS3150 Solar Film Sales Kit

Product Description

After unpacking, please place the accessories according to the picture below. The name and function of each accessory are as follows. The serial number below corresponds to the serial number in the figure

Glass test slot

It can be used to fix materials such as heat insulation glass and stick-film glass. The width can be adjusted by screws less than or equal to 10mm)

150W Philips infrared light

After turning on the light, the intensity of infrared light can be manually adjusted through the knob switch, which is used to simulate infrared light in the sun

Retractable UV flashlight

It is for simulating the ultraviolet rays of the sun, and achieves a concentrating effect by telescoping to adjust the UV intensity and supports USB charging

LS122 infrared power meter (next to infrared light)

Placed on the same side of the infrared lamp, it is developed to measure the reflection and heat insulation effect of the measured material. The higher the measured infrared intensity, the better the reflection and heat insulation effect is

LS123 UV power meter

Measure the intensity of ultraviolet light passing through the material and calculate the ultraviolet rejection rate of the sample by using the data before and after the material is inserted

Glass radiometer

When infrared rays irradiate the glass radiometer, the blades will rotate. The speed is proportional to the intensity of the infrared rays. If a material with better heat insulation is used to block the infrared rays, the speed of the blade rotation will be significantly reduced

LS122 infrared power meter (opposite the infrared light)

Measure the intensity of infrared rays passing through the measured material and calculate the infrared rejection rate of the sample through the data before and after the material is inserted